EZOTL8WS*1A LZOTL8WS*1A
Page 12
1000005927 (Rev. C - 08/21)
7/16” BOLT HOLES FOR
FASTENING UNIT TO WALL
UNIT CENTER LINE
TOP COVER
MOUNTING
SCREWS
Fig. 8
Fig. 9
31
Bottle Filler Installation Instructions
1)
Remove two (2) mounting screws
with 5/32” Allen wrench holding top cover to Bottle Filler (See Fig. 9). Remove top cover. Note do not discard mounting screws, they will be
needed to reinstall top cover.
2)
Remove wall mounting plate
from Bottle Filler. Place wall plate against wall on top of basin. Center the wall plate side to side with the basin. Mark the six (6) mounting holes
with a pencil (See Fig. 2, 3, 4 or 5).
3)
Remove wall mounting plate
from wall.
NOTE
: Mounting plate
MUST
be supported securely. Add fixture support carrier if wall will not provide adequate support.
4)
Install wall mounting plate
to wall using six (6) 7/16” obround mounting holes (mounting bolts not included) (See Fig. 8). Use appropriate fasteners for your wall type.
5)
Lay Bottle Filler on water cooler basin
and cut insulation from tube even with bottom of gasket, remove this insulation from the 3/8” tube, but do not discard.
Feed the power cord and waterline through the hole on top of water cooler.
NOTE:
To prevent scratching the basin place a towel or soft cloth over the entire basin when
working above it.
6)
Install gasket
on bottom of bottle filler tower with gasket support bracket & (2) screws (See Fig 11).
7)
Feed power cord
& 3/8” water line through hole in tower/basin gasket (See Fig 10).
8)
With the power cord,
wire(s), and waterline through hole on top of water cooler place Bottle Filler on the three (3) angled tabs protruding from the wall mounting plate installed
on wall. Make sure round boss in gasket fits in hole of basin.
9)
Once Bottle Filler is installed
on wall plate tabs, make sure the water line, wire(s) and power cord are installed properly. Inspect for leaks and fix all leaks before
continuing. Push the top of Bottle Filler toward wall and line up top cover two (2) holes.
10)
Reinstall Top Cover
on Bottle Filler (See Fig. 9) with two mounting screws from step 1 above. Caution, do not over tighten screws.
11)
Install remaining tube insulation
to the water line from bottle filler, connect Bottle Filler waterline inside of the water cooler by connecting the 3/8” water line to the tee.
12)
Install filter cartridge,
remove filter from carton, remove protective cap, attach filter to filter head by firmly inserting into head and rotating filter clockwise.
13)
Turn water supply on
and inspect for leaks. Fix all leaks before continuing.
14)
Once unit has been inspected
for leaks and any leaks found corrected, plug Bottle Filler and unit into wall for correct electrical cord routing
and connections (See Fig 28), be sure to reinstall fuse to the circuit or switch the circuit breaker back to the “ON” position.
15)
Once power is applied to Bottle Filler,
the GREEN LED light should illuminate showing good filter status along with the LCD Bottle Counter.
16)
Verify proper dispensing
by placing cup, hand, or any opaque object in front of sensor area and verify water dispenses.
NOTE:
The first initial dispenses might have air in
line
which may cause a sputter. This will be eliminated once all air is purged from the line.
17)
Once unit tests out,
install Lower Panel back on water cooler(s). Unit is now ready for use.
Fig. 11
Fig. 10
BRACKET & SCREWS
