
(630) 574-8484
7
Elkay Manufacturing Company
Installation Manual (1000005232 Rev. D - 08/21)
In-Wall Filtered Water Dispenser
3. Installation Preparation - Read Before Beginning Installation
For correct and safe installation, please read these
instructions completely.
DANGER
• All Installation work must be performed by an
authorized service personnel.
• Disconnect electrical supply serving the
Installation area to reduce risk of electrocution.
• Unit not suitable for installations where water jets
could be used.
WARNING
• Shut off water supply serving the Installation area
to reduce risk of water damage.
• Ensure proper ventilation by maintaining
clearance from cabinet louvers to wall on each
side of Cooler as specified in Rough-In.
• Never wire compressor directly to electrical
supply.
•
Thoroughly flush all water lines and fittings of all
foreign matter before connecting to Cooler.
• Warranty is void if Installation is not made
in accordance with current Manufacturing
instructions.
CAUTION
• Hose-sets are not to be used for connecting to
water mains.
• If inlet pressure is above 105 psig (0.72 MPa),
a pressure regulator must be installed in water
supply line. Any damage caused by reason of
connecting this product to water supply line
pressure outside it’s rated pressure, is not
covered by warranty.
• Tools/Items required but not provided.
- Water Shut-off Valve with 3/8” (9.5mm)
compression outlet.
- Waste Trap (non-metallic)
- Safety Glasses
- Protective Gloves
- Hex drives
- Fasteners for wall type
NOTICE
The installation of this product
requires electrical and plumbing
connections that use specific skills and knowledge. If
you are unsure or not qualified to make these
connections, consult a qualified plumber, electrician,
or installer for this installation. Professional
installation is recommended.
1. This water dispenser is designed for indoor use only
and should not be installed outdoors or in a humid
environment. This water dispenser should not be
installed on exterior walls.
2.
Location planning for remote filter, chiller and optional
drain is crucial based on chosen configuration. The
location of the water dispenser must be within 15 feet
of the remote water filter and chiller. Both must be in
an accessible location.
For chiller installation, ensure adequate ventilation
space as outlined in chiller manual. It also must be
located after the filter for proper filtration and cooling
(see figure below).
Water
Filter
Water
Chiller
Water
Dispenser
NOTICE
A water supply pressure below
40 psi will result in decreased
water flow through the unit and damage to the
product. A pressure above 105 psi will also cause
damage to the product.
3. Make sure the water supply pressure to the product
is between 40 and 105 psi. The water dispenser with
filter requires 40 psi minimum water pressure. The
optimum water pressure is 60 psi. The noise level is
lower than 70 dB.
4. Use care when opening and removing the packaging
to prevent damage to the product.
a. Inspect the product for any shipping damage and
report it immediately to the location of purchase.
Installation of a damaged product will void the
warranty.