0000001496 (Rev. F - 08/17)
EMASM*A
Page 4
INSTALLATION INSTRUCTIONS
ALCOVE
DRAIN TRAY
TOP COVER
FRONT VIEW
REAR VIEW
BACK PANEL
OUTER
WRAPPER
Pre-Installation (reference Rough-In, Fig. 1 and Fig. 3)
1.
Ensure Wall is structurally sound
to bear the loads imparted by the EMASM Bottle Filler
(On-Wall Bottle Filler). If necessary, install a Wall Support Carrier (not supplied).
2.
Ensure Water Supply Line and Drain Line are sized
and located as specified the Rough-in diagram.
3.
Attach Service Stop Valve (not supplied) to Water Supply line
orienting the 3/8"O.D. female compression
outlet horizontally to the left. Purge water line and test for leakage. Correct any leakage.
4.
Ensure package contains the following components:
Wall Mounting (reference Rough-In, Fig. 1 and Fig. 3)
1.
Remove Top Cover from Bottle Filler
by removing two (2) screws from top of unit. Use a 5/32" hex wrench (not
supplied).
2.
Remove Bottom Cover from Bottle Filler
by removing two (2) screws from bottom of unit. Use a 5/32" hex
wrench (not supplied).
3.
With the Top and Bottom Covers removed,
the Back panel is now free to be removed from Bottle Filler.
4.
Fasten Back Panel to structurally secure wall
through five 7/16" obround holes with fasteners appropriate for
wall type. Locate Back Panel as specified in Rough-In. If necessary, attach to Wall Support Carrier (not supplied).
5.
Ensure Back Panel is not obstructed
by the roughed-in Water and Drain Lines. If Back Panel is prevented from
seating properly, reposition Water and/or Drain Lines slightly until the Bottom Cover fits easily.
6.
Before hanging the On-Wall Bottle Filler,
ensure the Insulated Waterline is routed inside of the Wrapper If
outside the Wrapper, reposition to inside or else the unit cannot be installed properly.
7.
Hang the Bottle Filler onto the Back Panel,
aligning two tabs into the top of the Back Panel.
8.
Secure Bottle Filler to Back Panel
by replacing Top Cover on top of unit and fastening with two (2) supplied
screws.
9.
Replace the Bottom Cover
on bottom of the unit and fasten in place with two (2) supplied screws.
EMASM UNIT SHOWN
INSULATED
WATERLINE
BOTTOM COVER
DISPENSING
NOZZLE
TOP SCREWS
BOTTOM SCREWS
INSTALLER TO SUPPLY:
SHUT OFF VALVE
