Page 2
M1XRFEG Installation Manual
Table of Contents
General Installation and Setup ..................................................................................................... 4
Setting the M1XRF Data Bus Address and the Starting Wireless Zone ID ............................................... 5
Data Bus Enrollment:: .............................................................................................................................. 6
Data Bus Address Switches..................................................................................................................... 6
Operation ....................................................................................................................................... 7
Handling Received Transmissions: .......................................................................................................... 7
Diagnostic LEDs: ..................................................................................................................................... 7
Transmitter (RF) Level Checking [Signal Strength]: ................................................................................. 7
List of supported Transmitters - GE "UTC" Format (319.5MHz) & Brand ................................. 8
List of compatible Transmitters (319.5MHz) made by Resolution Products ............................. 9
Programming via Keypad ........................................................................................................... 10
Appendix A - Data Bus Selection Tables ................................................................................... 12
Appendix B - Examples of Zone Configurations ...................................................................... 14
Appendix C - Installing Multiple Redundant Receivers ............................................................ 15
Appendix D - Updating Firmware in the ELK-M1XRF ............................................................... 15
This device complies with Part 15 of FCC Rules which are designed to provide reasonable protection against such interference in a residential installation. The FCC
requires the following statement for your information:
This equipment generates and uses radio frequency energy and if not installed and used properly, that is, in strict accordance with the manufacturer’s instructions,
may cause Interference to radio and television reception. It has been type tested. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
* If using an indoor antenna, have a quality outdoor antenna installed.
* Reorient the receiving antenna until interference is induced or eliminated.
* Move the receiver away from the security control.
* Move the antenna leads away from any wire runs to the security control
* Have the device or controller plugged into a different outlet so that it and the receiver are on different branch circuits.
If necessary, the user should consult the dealer or an experienced radio/television technician for additional suggestions. The user or installer may find a booklet titled
“Interference Handbook” prepared by the Federal Communications Commission helpful: This booklet is available from the U.S. Government Printing Office,
Washington, DC 20402. The user shall not make any changes or modifications to the equipment unless authorized by the Installation Instructions or Users Manual.
Unauthorized changes or modifications could void the user’s authority to operate the equipment.
FEATURES:
•
Adds up to 144 individual wireless zones (sensors/points)
•
Operates from the 4 wire RS485 Data Bus
•
Multiple Receivers (up to 11) may be connected to a single M1 or M1EZ8 Control for redundancy and greater coverage
•
Flash Memory allows field updating of operating Firmware
•
Compatible with many models of GE branded Wireless Sensors, including other brands which comply with the GE protocol.
SPECIFICATIONS:
•
Sensitivity: >105 dbm
•
Operating Temperature: 0 to +120 degrees F
•
Operating Voltage: 12 Volts D.C.
•
Current Draw: 25mA
•
Indoor Range: 300 to 500 ft. ** line of sight
** Laboratory tests have achieved greater distances, however walls and metal objects generally reduce actual operating range.
Содержание ELK-M1XRFEG
Страница 16: ...Page 16 M1XRFEG Installation Manual ...
