Eliwell TelevisGo, Руководство пользователя

Страница: 16 / 68

Televis
Go Page 16/68
To install Televis Go , you have to set up the device and the network of devices it is connected to first.
This can be done via the WEB interface.
NOTE1
: Before scanning the network with Televis
Go
, each device in the network must be assigned a unique address by
setting parameters “FAA” and “dEA” (family:device).
NOTE2 : On plugging in, Televis Go does not switch on immediately as some checks are run automatically and the software
is loaded (takes about 30 seconds).
5.1 DEVICE SETTINGS
5.1.1 SETTING DATE&TIME
To set the plant name and date & time in the device, go to:
Computer Information General
To access this section, data logging must be suspended (see Data Logging section).
In the window that opens, click the icon or Edit .
Now you can enter the date and time then click the icon or
Save
.
The date and time can be imported directly from your computer by clicking the “
Use client date/time
” button.
Click the icon or Cancel to exit without saving the changes.
If you change page without saving, any changes made will be lost (the same as clicking Cancel).
IMPORTANT
: Changing the date/time may cause your Web session to expire. In this case, you may need to re-connect.
5.1.2 ENTERING THE PLANT NAME
To set the plant name in the device, go to:
Computer Information General
In the window that opens, click the icon or Edit .
You can now enter the Plant name then click the icon or Save .
Click the icon or
Cancel
to exit without saving the changes.
If you change page without saving, any changes made will be lost (the same as clicking Cancel).
5.1.3 SETTING NETWORK IP/DNS
To set the network IP/DNS, go to:
Computer Information Network Settings
In the window that opens, click the icon or Edit .
5. INSTALLATION / MAINTENANCE