ELITEL V700L, Руководство пользователя

Страница: 70 / 89

V700L Managed Single Master / Slave LAN Extender
USER’S MANUAL Ver. B.2
69
Appendix A: Cable Requirements
A.1 Ethernet Cable
A CAT 3~7 UTP (unshielded twisted pair) cable is typically used to connect the Ethernet device to the Modem. A 10Base-T
cable often consists of four pairs of wires, two of which are used for transmission. The connector at the end of the 10Base-T
cable is referred to as an RJ-45 connector and it consists of eight pins. The Ethernet standard uses pins 1, 2, 3 and 6 for
data transmission purposes. ( Table A-1 )
Table A-1 RJ-45 Ethernet Connector Pin Assignments
PIN #
MDI MDI-X
Figure A-1 Standard RJ-45 repectacle/connector
Signal
Media Dependant
interface
Signal
Media Dependant
interface-cross
1 TX+ Transmit Data + RX+ Receive Data +
2 TX- Transmit Data - RX- Receive Data -
3 RX+ Receive Data + TX+ Transmit Data +
4 -- Unused -- Unused
5 -- Unused -- Unused
6 RX- Receive Data - TX- Transmit Data -
7 -- Unused -- Unused
8 -- Unused -- Unused
Note:
Please make sure your connected cables have the same pin assignment as the table above before deploying the cables into
your network.