11
SECTION 1
INTRODUCTION
1.1 Aerospray TB Stainer Overview
Table 1: General Specifications (continued)
Table 2: Performance Specifications
Category
Characteristics
Reagent Spray Nozzles
Each reagent has a separate spray nozzle* to
dispense the correct amount of reagent.
*The D reagent sprays through two nozzles.
Reagents
NOTE:
Use only Elitech Group reagents, with diluents
as specified for Elitech Group concentrated reagents.
REF numbers for this stainer begin with one of the
following: SS-061 or SS-161. See Appendix D for
detailed information about reagents.
A - Decolorizer
B - Counterstain
C - Primary Stain (fluorescence or carbol fuchsin)
D - Deionized or distilled water
NOTE
:
Deionized or
distilled water is not provided by
Elitech Group and must be obtained locally. Water
should be filtered (0.2 micron inline filter) to remove
bacteria and particulates.
E
–
“Approved” ethanol, methanol, or reagent alcohol
NOTE:
Approved
ethanol or methanol must be 99.5%
pure.
NOTE:
Approved reagent alcohol must meet the
following specifications:
• Greater than 90% ethanol
• Approximately 10% isopropyl alcohol or methanol
• Less than 0.5% water
• No ketones
Stain Settings
Up to 12 programs (stored)
Category
Characteristics
Pollution Degree
2
Heat Dissipation
Maximum
Average During Staining
Average While Idle
512 Btu/hour
102 Btu/hour
41 Btu/hour
Maximum Sound Emission
72 dB
