Elite 4'3" wide compact, Инструкции и иллюстрации

Страница: 20 / 28

The first operation is to connect the two side frames to the end frames to form the outer shape of the
completed structure. Another pair of willing hands would be useful at this stage.
1. Lift the first side frame into its position by the rear end.
2.
Slot the eaves bar into the small space between the roof and side corner bar so that the
gutter is outside the end frame and the two flanges that form the angle of the roof and
side are inside and tight up against the bolt slots of the roof and side corner bar.
(Key
Point).
3. The extra bolts that were inserted in the bolt slots during the gable end assembly can
now be used.
4.
Line up the elongated holes in the flanges of the eaves with the bolt slots and slide the
bolts into them. Put nuts on and tighten up
. (Key Point).
5. The built in base attaches to the inside of the side corner bar. The bolt placed in the side
corner bar bolt slot at gable end assembly will slide down into the slotted hole at the end
of the built in base. Likewise with the corner bracket, this can now be attached to the end
built in base utilising the bolts inserted at frame assembly.
6. Do the same at the other three corners.
7.
Slide the glazing beading into both sides of the ridge before attaching the ridge to the
roof corner bars. Insert the end of the ridge through the small gap in the roof corner bars
at the top, the vertical part of the ridge will be outside, pointing skywards and the two
flanges that form the angle of the roof will be inside, tight up against the bolt slots of the
roof corner bars.
8. Line up the slotted holes at the end of the ridge with the bolt slots in the roof corner bars.
Push the two bolts, previously inserted during the gable end assembly into the slots. Put
on nut and tighten.
9. The roof bars can now be attached to the ridge and gutter. Slide the glazing beading into
the roof glazing bars first. There are two channels per bar that require beading but glaz-
ing beading is not required in the part of the
glazing bar that goes under the vent. Attach
them to the ridge first by sliding a bolt into
the bolt slot of the glazing bar and inserting it
through the hole in the flange of the ridge.
Put a nut on and tighten up. Do the same
with the rest of the roof bars.