Elite 4'3" wide compact, Инструкции и иллюстрации

Страница: 12 / 28

4. Attach the rectangular plate (with 3 elongated holes) to the 2 bolts inserted in the glazing bars
and the last bolt inserted into the built in base ensuring that the glazing bar is tight down into the
angle of the door end cill. Attach the diagonal angle to the top bolt of the rectangular plate. The 2
unoccupied bolts in the built in base sections will be used to anchor the greenhouse to the floor.
5.
Attach the main door track support (shaped like a letter
‘Z’ to be found with the door panels) to the two bolts that secure
the glazing bars to the corner bars.
(Key Point). This ‘Z’ shaped
bar must be fitted with the two outside slots facing upwards (as
illustrated)
not downwards. The main door track support attach-
es to the upper bolt by going between the corner bar flange and
the glazing bar. (Key Point).
6. The two door end horizontal angles attach to the top bolt
in the gusset plate and the vertical glazing bars.
7.
Stand the frame up and bolt the door track to the main door track support and the small angle
door track support by inserting 3 bolts into the bolt slot of the door track. Position 3 of these
through the 3 holes in the door track support above the door opening. At this stage you do not need
to adjust the track for level or square. This will be done later when fitting the doors.
8.
Insert 2 extra bolts into each end of the door track which will be used later during general as-
sembly.
9.
When this has been achieved tighten all nuts.
10. Slide a bolt into the bolt slot in the built in base section, one at each end. Attach the corner
bracket so that it is pointing downwards. If you are fitting your greenhouse onto soft ground, then
do not fit the corner bracket yet. If you are on a patio, you will need to cut the corner bracket off
level with the bottom of the built in base and slide extra bolts into the bolt channel to which will be
attached the anchor brackets (generally 1 every 2’). If you are on soil, the corner bracket will go in-
to the ground at general assembly.
N.B. Please note carefully the correct position of the main door support. The slotted holes at either
end are facing skywards NOT downwards.
(Key Point).