Edge Frame Projection Screen
User’s Guide
Rev.10252019MZ
10
Edge trim Installation
Included is an ultra-thin black edge trim that provides an elegant bezel finish
1.
Place the assembled frame on a flat and clean surface. The projection screen surface should be facing
up.
a.
As an option, Black Tape is supplied to cover any possible gaps between the pieces of the bezel
trim. Align the tape with the edge of the screen, as shown in Figure 1. Once properly aligned,
apply the black tape to the center of the top and bottom of the screen material.
Figure 1
2.
Without removing the adhesive tape, place all the trim pieces along the edge of screen material. Adjust
the trim so that the top and bottom trim pieces are touching and show no gaps in the center. (Note: The
Elite logo should be positioned on the bottom right). Refer to Figure 2 below for a visual reference.
NOTE: Make sure the bottom edge trim with the Elite Screens logo is installed on the correct side. The
back of the material should be labeled with a DOWN sticker to indicate the material is facing in the down
position. The Elite Screens logo should be installed on the DOWN side
Edge trim x 6 pcs
Black tape x1pcs
Trim
strip
Screen Material
The black
tape
Front Side
Back Side
Plastic corner sleeve x4pcs
The black tape
Figure 2
TIP:
Align the trim
starting from the
center to reduce
gapping. Any gaps
left at the corners
will be covered by
the corner sleeves.
White area
signifies
corner gap.
Figure 1
