Elite Greenhouses STREAMLINE Series, Инструкции и иллюстрации

Страница: 25 / 32

25
FITTING THE DOOR LOCK
The door lock must be fitted after the doors are in position
(Key Point). Undo the ring bolt from the
door lock, and insert the barrel through the hole in the panel from the outside. Re-attach the ring
bolt to the barrel on the inside, and tighten.
Now attach the cam lever, washer and screw to the door lock from the inside position of the door.
The lock will turn through 90 degrees both ways, so you must ensure the cam (when fitted) is point-
ing skywards (unlock position) and horizontal (locked position).
Now using a cropped head bolt, attach the domed pin to the bolt channel of the handed door post on
the left hand door (viewed from outside). Move the pin up or down in the channel so that the notch
on the cam locates comfortably
when horizontal. Tighten all
components.
FINISHING OFF
To prevent the door from sliding past its opening, you must
fix 2 angle brackets to the door end assembly. Insert a cropped
head bolt into the bolt channel at the top of the left hand glaz-
ing bar (viewed from the inside) and fix and angle bracket as
shown in the picture below.
The bracket must be fitted at the same height as the door panel
so that, as the door moves left or right, the bracket prevents
the door from moving too far along the top door track.
Repeat at the bottom of the door.
Repeat for the 2nd door.
To facilitate smooth running of the door, fit 1 flat bar at each
end of the top door track.
The flat bar has 2 holes of different size.
Loosely fix the larger hole to the bolt channel at the back of
the top door track using a short bolt and allow the flat bar to
hand vertically down.
Move the flat bar along the top door track until the small hole in the flat bar meets the self tapping
screw groove in the roof corner bar.
Fix the small hole in the flat bar to the corner bar using a self tapping screw.