5
1)
Mains connection
The unit is manufactured to run on 200-240 V, 50/60 Hz. Before connecting them for the first
time, make sure that your mains supply and the rating set on the equipment (electrical
specification plate) are compatible.
2)
Check that the mains switch (
4
) is OFF
3)
Insert mains cable to the MAINS INLET (
1
) and connect to a FULLY EARTHED OUTLET
4)
Using the mains switch (
4)
and switch the unit ON (switch illuminated)
5)
Connect lampheads ensuring that lampheads switches (
22
) are OFF, i.e. display NOT illuminated
6)
Select charging rate (
3
) "normal"
7)
Select modelling lamp setting (
16
)
8)
Connect the synchro cord on the socket (
7
)
9)
Check that photocell (
6
) is OFF (not illuminated)
10)
Switch on the lampheads : the touch (
22
) switches individually the flash circuits and modelling lamps
11)
Select the power with the touch
(+
or
-).
12)
The green open flash button (
8
) will light up, indicating that the unit is ready for operation.
Operating instructions
According to the safety regulation: we draw your attention to the fact that this
equipment should be used only in a dry environment; it must be protected from
dripping water and from extremely dusty conditions. The unit must ALWAYS be
plugged into an EARTHED electrical socket.
