Elimko E-PR-200 Series, Руководство пользователя

Страница: 21 / 56

Elimko
E-PR-200
KY-PR200-0420-0 PAGE
21/56
Output states of the Digital Output cards for test purposes can be changed by pressing corresponding ON and
OFF buttons. There is no testing and calibration page of digital input cards. Like the digital output cards,
relays states can be changed by pressing ON or OFF in Relay Card Test page for test purposes.
Figure 6.8 Hardware Relay Output Test Page
Analog Input Card Calibration Adjustments:
For the calibration of Analog Input cards, firstly, the channel to be calibrated should be selected from
Channel
window. The calibration parameters are explained below. From a general point of calibration
operations, required signals specified below are applied to the correspoinding channels and
Press to
Calibrate
button is pressed. After stable value was seen, the value is recorded by selecting the same
button.
Cancel
button is used to cancel active calibration.
Figure 6.9 Analog Input Card Calibration Page
50 mV:
Set the calibrator as a millivolt source and adjust the calibrator output 50.000 mV. Apply the
calibrator output to the millivolt input of the related channel.
TC (SHORT), CJ-NTC (3 k):
Set the calibrator as a resistance source and adjust the calibrator output 3000.00
Ω. Short circuit the TC input terminals of the related channels. Apply the calibrator output to the input
terminals of the related channel.
20 mA:
Set the calibrator as a milliampere source and adjust the calibrator output 20.00 mA. Apply the
calibrator output to the milliampere input of the related channel.
10 V:
Set the calibrator as a voltage source and adjust the calibrator output 10.00 V. Apply the calibrator
output to the volt input of the related channel.
390 Ohm:
Set the calibrator as a resistance source and adjust the calibrator output 390.00 Ω. Apply the
calibrator output to the RT input of the related channel. 3. RT line should be short-circuited by the wiring
diagram.
390 Ohm Line:
Same as 390 Ohm. Just save after making 390 ohm calibration without changing anything