9
đƫ
Secure the top of the duct with 2 assembly screws
provided.
đƫ
Secure the bottom of the duct with 2 assembly screws
provided.
đƫ
Install the grease filter and turn power on at service panel.
Check operation of the hood.
If range hood does not operate:
đƫ
Check that the circuit breaker is not tripped or the house
fuse blown.
đƫ
Disconnect power supply. Check that wiring is correct.
To get the most efficient use from your new range hood, read
the “Description of the Hood” and “Control” sections.
Keep your Installation Instructions and Use and Care Guide
close to range hood for easy reference.
Installation- Ductless (Recirculating) version
I
CAUTION
To install the hood in this version, first purchase the
Ductless Recirculating Kit.
includes:
charcoal filter and deflector
đƫ
If possible, disconnect and move freestanding or slide-in
range from cabinet opening to provide easier access to
rear wall. Otherwise put a thick, protective covering over
countertop, cooktop or range to protect from damage and
debris. Select a flat surface for assembling the unit.
Cover that surface with a protective covering and place all
canopy hood parts and hardware in it.
đƫ
Determine and mark the centerline on the wall where the
canopy hood will be installed.
đƫ
Select a mounting height comfortable for the user and
mark on wall.
đƫ
Tape template, matching center-line and hood bottom.
Mounting the duct cover bracket
The duct bracket should be installed against the back wall
and flush with the ceiling.
This bracket will hold the telescopic duct cover in place at
the top.
Secure the bracket to the wall:
đƫ
Align the marked centerline on the bracket with the
centerline on the wall.
đƫ
Mark 2 screw hole locations in the wall.
đƫ
Drill
5
⁄
16
” pilot holes in the marked locations.
đƫ
Install wall fastener anchors.
đƫ
Drive wood screws, by hand, into the fastener to allow
anchors to expand. Remove the screws.
đƫ
Secure the bracket to the wall with wood screws and/or
fasteners.
Ceiling
Wall
V
ertical C
ent
erline
House wiring location
đƫ
The junction box is located on the top left side of the
hood.
đƫ
Wiring should enter the back wall at least 20
1
⁄
4
” above
the bottom of the installation height, and within 7
5
⁄
8
” and
4
7
⁄
8
”of the left side of the centerline.
Install framing for hood support
đƫ
If drywall is present, mark the screw hole locations.
Remove the template.
đƫ
Cut away enough drywall to expose 2 vertical studs at the
holes location indicated by the template.
Install two horizontal supports at least 4” x 2” between
two wall studs at the bottom and upper mounting holes
installation location.
