MANUAL CH-53, FOR EXTERNAL MOTOR
Before installation or use of the
product, please read this manual
carefully.
Important!
MAINTENANCE
SAFETY
Avoid using easily flammable fluids near the product. Do not flame under the product!
Always use extreme caution when frying with grease. Grease used several times is very flammable.
Keep nearby something you can use to extinquish possible flames.
Do not use open grill under the product.
THERE IS A DANGER OF FIRE IF THE PRODUCT IS NOT CLEANED
ACCORDING TO THE MANUAL!
Installation height: we recommend 50-60cm above stowe.
(Minimum 65cm with gas stowe)
Product must not be connected to flue exhausting smoke gas (for example fireplace)
Connecting to exhausting flue, local fire safety must be considered.
Adequate compensation air must be arranged if the product and for example fireplace are used
simultaneously. Negative pressure might direct smoke gases from fireplace back to the room.
This can be prevented by opening the window.
Class 1 electric product.
Product must be installed according to 3-pole overvoltage standards.
Product must be able to be switched off from power network!
Always unplug the product from power network before cleaning or maintenance.
GENERAL SAFETY
Unnecessary maintenance costs can be avoided and long life of product can be assured if the given
instructions will be followed.
Cleaning the grease filter
: In maintenance of the product, it is very important to keep grease filters
clean. Grease filters must be cleaned after 30 hours of use, but at least every 2 months.
Product is equipped with grease filter cleaning reminder.
Removing the grease filter:
Press the locking and remove the grease filter.
Wash by hand or in dishwasher. In handwash, use brush and alkaline washing liquid.
When the grease filters are replaced, press the
R
button (few seconds) of the control panel to reset the
timer. After 30 hours, cleaning reminder appears to display again.
Other functions of the control panel are mentioned in the last page section ”CONTROL PANEL”
Cleaning other surfaces:
Product must be kept clean. Grease spatters must be cleaned punctually.
Do not use abrasive or corrosive liquids. Use only liquids suitable for metal surfaces.
Always follow the instructions from the washing liquid package!
EN
CH-53 11/2008