6
Ducting options
Closely follow the instructions set out in this manual.
All responsibility, for any eventual inconveniences, damages or fires caused by not complying with the instructions in this
manual, is declined.
Ducting version
Ductless (Recirculating)
The hood is equipped with a 6” (15.2 cm) round transition
for discharge of fumes to the outside.
Roof Venting
Wall Venting
A
B
A
B
A. Roof
cap
B.
6” (15.2 cm) round vent
A. Wall
cap
B.
6” (15.2 cm) round vent
In cases where it should
not be possible to dis-
charge cooking fumes and
vapour to the outside.
Attach a charcoal filter and
the deflector on the duct
cover support bracket.
Fumes and vapours
are recycled through the
top grille by means of a
duct connected to the
transition and the transition
mounted on the deflector.
For this version only:
purchase the Ductless
Recirculating Kit.
Minimum Duct Size:
6” Round Pipe.
B
A
A. Deflector
B.
6” (15.2 cm) round vent
Preparation
Do not cut a joist or stud unless absolutely necessary. If a joist
or stud must be cut, then a supporting frame must be
constructed.
Fittings material is provided to secure the hood to most types
of walls/ceilings.
However, a qualified technician must verify suitability of the
materials in accordance with the type of wall/ceiling.
Before making cutouts, make sure there is proper clearance
within the ceiling or wall for exhaust vent.
Recommended installation height:
Hood installation height above cooktop is the users preference,
as long as the recommended measures has been respected.
The lower the hood is above the cooktop, the more efficient
the capturing of cooking odors, grease and smoke.
I
CAUTION
FOR GAS RANGES INSTALLATION: MOUNT THIS HOOD SO
THAT THE BOTTOM EDGE IS AT 30” (76,2 CM) ABOVE THE
COOKING SURFACE.
FOR ELECTRIC RANGES INSTALLATION: MOUNT THIS HOOD
SO THAT THE BOTTOM IS NOT LESS THAN 24” (61 CM) AND
NOT MORE THAT 30” (76,2 CM) ABOVE THE COOKING
SURFACE.
HOUSEHOLD USE. PLEASE, READ INSTALLATION MANUAL
FOR SPECIFIC APPLICATION.
Check your ceiling height and the hood height maximum
before you select your hood.
Installation- Ducted version
đƫ
If possible, disconnect and move freestanding or slide-in
range from cabinet opening to provide easier access to
rear wall. Otherwise put a thick, protective covering over
countertop, cooktop or range to protect from damage and
debris. Select a flat surface for assembling the unit. Cover
that surface with a protective covering and place all cano-
py hood parts and hardware in it.
đƫ
Determine and mark the centerline on the wall where the
canopy hood will be installed.
đƫ
Select a mounting height comfortable for the user and
mark on wall.
đƫ
Tape template, matching center-line and hood bottom.
Mounting the duct cover bracket
The duct bracket should be installed against the back wall
and flush with the ceiling.
This bracket will hold the telescopic duct cover in place at
the top.
Secure the bracket to the wall:
đƫ
Align the marked centerline on the bracket with the
centerline on the wall.
đƫ
Mark 2 screw hole locations in the wall.
đƫ
Drill
5
⁄
16
” pilot holes in the marked locations.
đƫ
Install wall fastener anchors.
đƫ
Drive wood screws, by hand, into the fastener to allow
anchors to expand. Remove the screws.
đƫ
Secure the bracket to the wall with wood screws and/or
fasteners.
