ELGO Electronic Z58-600 Series, Руководство по эксплуатации

Страница: 15 / 28

Installation and First Start-Up
- 15 -
8.2 Installation of the indicator
8.2.1 Panel Housing (standard)
The position indicator is intended for installation in a panel cut-out with the dimensions W x H = 93 x 67 mm.
For mounting a 1 slotted screwdriver and 1 Phillips screwdriver is required. Then proceed as follows:
1. 2. 3.
Figure 5: Installation into panel
1. First slide the position indicator into a suitable panel cut-out.
2.
Then loosen the two Phillips screws of the diagonally mounted mounting brackets on the rear. Turn the two
mounting brackets so that the threaded holes point outwards and then tighten the Phillips screws.
3. Now insert the provided grub screws into the threaded holes of the mounting brackets and turn clockwise
until the device is firmly seated in the cut-out.
8.2.2 Built-on Housing (Option „A“)
In order to fasten the device by using two M6 screws, the built-on housing has two insert nuts on the underside
(see figure below). The hole distance is 60 ±0,2 mm (see

6.3).
Figure 6: Housing underside with insert nuts
ATTENTION!
The length of the screws used must not exceed 15 mm! Otherwise
the electronics will be damaged and the device may be destroyed.
panel
grub scews
Phillips screw
panel from the
back side
mounting
bracket (2 x)
Z58 rear
panel
Screw max. 15 mm
Insert nut M6