ELGO Electronic Z58-600 Series, Руководство по эксплуатации

Страница: 17 / 28

Design and Functions
- 17 -
9.3 Parameter Level
9.3.1 Enter Paramater Level
Press F + Incr/Abs for 3 seconds at the same time:
 P 01 appears in the display („0“ is flashing)  the parameter level is active
The corresponding key functions for programming are described in the previous section  9.2.2.
9.3.2 Parameter Description
All available parameters are described in detail here:
P00 = Reserved for test purposes
P01 = The counting direction can be reversed here (setting 0 or 1).
P02 = No function / reserved
P03 = Selection of the decimal place
P04
= Actual value memory can be activated/deactivated here.
P05 = Keypad lock/ keypad enable (the parameter level always remains active)
P06 = Select the edge evaluation (x 1, x 2 x or x 4)
P07 = Measuring system selection:
The connected measuring system must be selected here:
Setting 0 = Inkrementelle Messsystemsignale A/B/Z (z. B. EMIX/LMIX/PMIX/FMIX oder Drehgeber)
Setting 1 = Incremental encoder signals A/A’, B/B’, Z/Z’ (for differential encoder types)
Setting 2 = Absolute signals of ELGO - EMAX (via RS422 interface)
Setting 3 = Absolute signals of ELGO - FMAX (via RS422 interface)
P08 = Multiplication factor:
For details of the pulse scaling refer to section

9.6.
P09 = Reference value:
A reference value can be entered here which is taken over into the display when keys F +
►
are pressed
or the external reference input is activated.
P10 = Tool-offset:
An offset dimension can be defined here. By pressing the
►
or activating the external tool-offset input
the display will add this value to the actual value.
P11 = Saw blade thickness (Incr-Mode only):
In order to compensate the thickness of a saw blade of a saw machine, the value can be stored here.
P12 = Preset limit for relay 1 (min) activates when underrun
P13 = Preset limit for relay 2 (max) activates when overrun
P14 = Display brightness:
To adjust the brightness of the LED display digitally from 0 (darkest) to 9 (brightest).
P15 = No function / reserved
P16 = Default parameters:
Details about resetting the Z58 to the default parameters can be found in section

9.5.
P17 = Measurement unit mm or inch:
Defines whether the position display is to be operated in millimeters or inches.
P20 = Analog (minimum value):
Enter the value at which the analog output controls 0 V resp. 0 / 4 mA.
P21 = Analog (maximum value):
Enter the value at which the analog output controls 10 V resp. 20 mA.
P22 … P98 are without function or reserved
P99 = Indicates the software version of the device (useful for service calls).
Note: A tabular overview of all parameters can be found in the parameter list
 9.4.