8
USER MANUAL
RPS/M/1K
Elettrotest S.p.A. P.zza R. Riello, 20/B - 45021 Badia Polesine ( RO ) - tel. +39 0425 53567 - Fax +39 0425 53568
e-mail:
http:
62000582 Rel.1.0 – 15/03/2018
2.
NOTES FOR USERS
2.1.
SWITCHING ON
RPS doesn't have power switch and so when the input connector is powered, RPS turns on. RPS
needs (after power on) less than 10 seconds to be ready.
2.2.
VOLTAGE FEEDBACK
The output voltage stabilization works the same in both the configurations on the RPS output
terminals (2 wire) and on a possible long distance outlet (4 wire), to compensate the voltage drop
due to cable connections. To work in 4WIRES configuration, you must perform the wiring as shown
in the figure below and set "4WIRE" mode via remote control.
RPS compensates the voltage drop on the connections up to 5% of the set voltage.
To prevent any overheating of the line, when the limit has been exceeded, RPS does not guarantee
that the value of output voltage is equal to the voltage set. In this case it displays an error signal
(see the paragraph VOLTAGE ALARMS).
