Elettrotest 1K, Руководство пользователя

Страница: 3 / 39

2
USER MANUAL RPS/M/1K
Elettrotest S.p.A. P.zza R. Riello, 20/B - 45021 Badia Polesine ( RO ) - tel. +39 0425 53567 - Fax +39 0425 53568
e-mail: info@elettrotestspa.it http: www.elettrotestspa.it
62000582 Rel.1.0 – 15/03/2018
1. RACK POWER SUPPLY
1.1. GENERALITY
1.1.1. INTRODUCTION
RPS is a power source that supplies a sinusoidal and stable voltage. Its output voltage is adjustable
in frequency and amplitude.
1.1.2. SAFETY WARNINGS
The manufacturer urges users to read the user’s manual for our products carefully before
installation.
The installation must be carried out by qualified technical staff. The non-observance of the
warnings in this manual can cause electric shocks, even fatal ones.
Please find below some general safety warnings.
V GENERAL WARNINGS

This equipment must be connected to the mains supply using the appropriate safety
devices. Please consult the relevant paragraph 5, in this manual.

RPS must be connected to safety ground through the apposite connections. The non-
observance or the degradation of this earth connection can lead to electric shocks, even fatal
ones. As regards the correct connection modes, please refer to the information contained in
paragraph 5.

Disconnect RPS from the mains before any work on the equipment and on the connected
power loads.

Before touching the load or the output connector make sure that the power supply on the
device has been disconnected for at least 5 minutes. This is the time necessary in order for the
capacitors inside the device to discharge. The non-observance of this discharge time can lead
to electric shocks, even fatal ones.

The output of RPS is not isolated respect to the main power supply and so NONE OF THE
TWO OUTPUT PHASES CAN BE CONNECTED TO THE GROUND.

Avoid heavy shocks to the equipment (especially during transport) or exposure to extreme
weather conditions.

Any damage to the product due to transportation, incorrect installation or improper use is
not covered by the guarantee supplied by the manufacturer.

Do not use the equipment in explosive environments or in the presence of dust, acids or
corrosive and/or inflammable gases.

Tampering with or dismantling any component in the equipment will cause the automatic
expiry of the guarantee.