4 • My first start-up
●
11
15. Partially assembled LCR-meter during the settings.
(Photo:Jean-Jacques Aubry)
Both the front panel and the MCU board can be slid out of the case,
giving access to all the adjustment points without the risk of accidental
electrical contact between the two boards!
If the MCU board does not slide smoothly, it may be necessary to
slightly file the edges of the PCB
Note: Completion of the assembly takes place later (§6, p.18).
4 • My first start-up
On the MCU board, turn switch SW1 to the
OFF
position. Then con-
nect the USB cable between J1 on the MCU board and a USB power
supply (e.g. from your smartphone). Slide SW1 to the
ON
position.
The display should light up. The message < BOOTLOADER V1.X > is
displayed for a short time, followed by the welcome screen, the cali-
bration prompts and the measurement screen.
Содержание 19883
Страница 2: ...2 MHz LCR Meter Kit AU2019 Assembly Manual 2...
Страница 33: ...Appendix LCR6 texts v3 txt 33...