Electrolux WE170P, Руководство по обслуживанию

Страница: 21 / 85

21
7 ALARMS
7.1 Displaying the alarms to the user
When a problem occurs in the appliance and a “WARNING” or “ALARM” is triggered, this is shown in the
three digit display (where the time left to the end of the cycle is shown), this information ceases to be
displayed when the problem is repaired/solved. The buzzer then emits a sound for 5 minutes. This does not
occur for alarm EH0.
The alarms displayed to the user are listed below:

E10 - Water fill difficulty (tap closed)

E20 - Drain difficulty (filter dirty)

E40 - Door open
While for the alarm:

EH0 – Voltage or frequency outside normal values
It is necessary to wait for power supply voltage and/or frequency to restore normal conditions.
The alarms are enabled during the execution of the washing programme. With the exception of
alarms associated with the configuration and the power supply voltage/frequency, which are also
displayed during the programme selection phase.
The door can normally be opened (except where specified) when an alarm condition has occurred, on
condition that:

The level of the water in the tub is below a certain level.

The water temperature is lower than 55 °C.

The motor has stopped.
Certain alarm conditions require a drain phase to be performed before the door can be opened for safety
reasons:

Cooling water fill if the temperature is higher than 65 °C.

Drain until the analogue pressure switch is on empty, during a max. 3-minute interval.