2 1
A
B
4
. Position the plastic cups so that the arrowed lugs
are flush with the front
and side of the top, then
press down onto the top.
Now break off the re-
maining tabs.
5
. Open the knock-out holes on the back of the
tumble dryer (where present)
with the aid of a hammer and
screwdriver. They must not
be fully removed, just ope-
ned!
6
Slide the tumble dryer
under the metal brackets,
keeping the front edge rai-
sed 1–2 cm.
7
. Lower the front feet of the
dryer into the plastic cups and
adjust the feet so that the dry-
er is level.
ADJUSTING THE FEET
Screw the feet in or out until the dryer is
steady and level
on the floor or
washing machi-
ne. Then tighten
the locking nuts.
Fit the stacking kit as follows:
1
. Unscrew the two arrowed screws at the rear of the
washing machine.
2
. Fit the metal brackets as shown, using the screws.
3
. The plas-
tic cups that will hold the front feet of the tumble
dryer must be attached to the top of the washing
machine. This is important since the feet of the
tumble dryer must be located in the plastic cups to
ensure that the dryer is correctly positioned.
Break tab
A
off the cup that goes on the right side
and break tab
B
off the cup that goes on the left
side. Then peel the
backing paper off the
self-adhesive base of
the cups.
MECHANICAL INSTALLATION
TUMBLE DRYER
Locking nut
