Electrolux FC48, Руководство по установке

Страница: 20 / 36

05306004
Page Notice Date
INSTALLATION
MANUAL
8
6
1004
6. Installation/
Putting into service
TABLE OF CORRESPONDENCES - Finishing cabinet FC48
Category Type Working Ø of Pressure at Heat Consumption Consum-
index of supply Hi injectors injectors emission ption
gas pressure Qn in kW Mn in Vn in
in mbar in mm (Hi) kg** m³**
* 2E, 2H, G 20 20 34,02 3,30 184 mmH
2
O 20 - 0,23
2ESI
MJ/m³
or 18 mbar
2L, 2ESI G25 25 29,25 3,70 184 mmH
2
O 20 - 0,27
MJ/m³
or 18 mbar
3 P G31 37 46,34 2,20
regulator out
20 0,16 -
MJ/kg of operation
3 P G31 50 46,34 2,10
regulator out
20 0,16 -
MJ/kg of operation
* For Belgium, no work is allowed between G20 and G25.
Note : G20 (H) = natural gas, Lacq type (20 mbar)
G25 (L) = natural gas, Groningue type (20 or 25 mbar)
G31 = propane gas (37 or 50 mbar)
**8 min typical cycle : 8 60/40 polyester-coton overalls of 550g, 61% retention rate, "high" drying temperature (85°C), with no cool
cycle, unit preheated for 3 min. at 85°C, loading/unloading time estimated at 2 min.
Check-out
Before leaving, put the appliance into operation and allow to run a
complete cycle. Watch to ensure that all burner system components
function correctly.
IMPORTANT
Tightness test after installation
The gas leak test is performed as follows :
1/ Paint pipe joints, pilot gas tubing connections and inspect outlets
with rich soap and water solution ; do not use an aggressive soap.
2/ Put the machine into service. Bubbles indicate a gas leak.
3/ Eliminate this leak.
NOTE : After all intervention, re-seal (red varnish) the following
adjustment organs :
- regulator of pressure.
In case of changing of gas, the stick for the adjustment has to be
modified.