7.
MAINTENANCE
periodically cleaned, in order to maintain the
performance of the shower.
Before removing the filter, turn off the main
water supply of the shower.
To remove the filter see Fig. 18 below.
Inspect the ‘O’ ring for damage when the
sharp object, as it will cause damage. It is
preferable to use an old toothbrush or similar.
NOTE:
Full commissioning procedure will need to
page 14 for information on commissioning
procedure.
Fig. 18
You can use a clean cloth to wipe the front
panel.
O-ring
Filter assembly
Do not use brushes, emery paper or
burnishes to clean the unit because it
may cause damages.
While cleaning the front panel
Do not use a chemically treated cloth or
duster to clean the unit.
Do not use benzine, thinner, polishing
powder or similar solvents for cleaning.
These may cause the plastic surface to
crack or deform.
WARNING!
7.1
General cleaning
7.2
Before maintenance work, you must
switch off the power at the isolating switch.
Do not remove the front panel.
Make sure that the sealing ‘O’ ring is in
place.
reassembly.
Do not spurt water to the unit.
It is advisable that the showering
temperature is satisfactory by testing with
your hand before stepping under the
showerhead. There will always be a time
delay of a few seconds between selecting
Turn the temperature control clockwise -
the shower and make the water hotter.
NOTE:
Total rotation distance of the temperature
knob is 300°.
To increase the shower temperature
21
ENGLISH
