7.
Once flushing out has been completed,
stop the water flow by pressing the On/off
button.
8.
Fit the showerhead to the flexible hose and
place in the showerhead holder(Fig. 17).
Fig. 17
The shower is now ready for normal operation.
Make sure the commissioning procedure
has been carried out.
Press the On/off button again and water
When not using the shower unit, insolate
the unit from main circuit via the double
pole switch.
Cold:
the cold setting does not provide
any heat from the heater to the incoming
water.
I(ECO):
Uses only the low power heating
element within the shower unit.
II:
Uses the high power heating element
within the shower unit.
III:
Uses both of the low/high heating
elements within the shower unit to provide
NOTE: It will take a few seconds for the
temperature to stabilise after changing the
Heating power knob position.
The water temperature is altered by
the water through the shower via the
temperature control.
After obtaining your showering temperature,
the knob can be left as the normal setting
and should only need altering to
compensate for seasonal changes in
ambient water temperature.
Turn the temperature control anti-clockwise
the shower and make the water colder.
NOTE:
The preferred knob position on
ECONOMY will give a different temperature
to the same position on HIGH.
To decrease the shower temperature
To adjust the shower temperature
(ECO and “II” or “III” settings only)
The power selector has four button -
Cold “
”, I(ECO) “
”, II “
” and
III “
”.
To start the shower
To stop the shower
To use the power selector
6.3
Daily use
If restarting immediately after stopping,
be aware that a slug of hot water will
WARNING!
6.
OPERATION INSTRUCTION
19
ENGLISH
