Electrolux EKK915AAOX, Руководство пользователя и инструкция по установке

Страница: 20 / 56

20 www.electrolux.com
Attention! If the appliance is going
to be installed free-standing (class
1) and if you use the flexible rubber
hose, it is necessary to follow the
instructions and the fig. 18 given
below:
Attention! On its route, the hose
must not touch any parts where the
over temperature is than 95°C.
Attention!
The hose must not be
subject to any kind of torsional
stress or tractive force, there must
be no pinched parts or really sharp
bends.
Attention! It must not touch
anything that can cut, that has
sharp corners, etc.
Attention!
The whole length of
the hose must be easy to inspect
in order to keep a check on its
condition.
Attention!
It must be replaced
within the date printed on it.
Securing the cooker to wall
Note:- The installation of the chain
provided is for safety reasons, it must
be installed as indicated below.
To prevent the cooker tipping forwards in
the event of children standing on the oven
door or where users put extreme weight
on the door when in open position, two
chains MUST BE fixed to the back of the
oven which should at all times be secured
to the threaded pins . The threaded pins
should be secured to the wall at the back
of the cooker. The chains should always
be attached to the upper threaded pins
when the cooker is in its position against
the wall. Pay attention in fact that the
chain must be fixed without slack.
Warning! If the cooker is installed
between two cupboards you must
drill a 16mm hole level to the safety
chain height on either cupboard
as far back as possible, locate the
cooker into position and pass the
safety chains through the 16mm
holes, with the cooker in final
position pull both safety chains and
secure them to the inside of the
cupboard with two screws on each
safety chain.
PLEASE TEST THAT THE COOKER
DOES NOT TILT FORWARD.
Assembly instructions
• Secure threaded pins into wall
immediately behind and to the left-
hand side about 770 mm from the
floor.
• Secure the chain under the nut before
using or cleaning etc. of the cooker
(see figure below).
Note for installer
• To prevent strain on the Flexible Hose
assembly, a chain & hook is necessary
approx. 100 mm up from the floor (not
provided).
• Attach the chain to the lower hooks
if the cooker is installed with a hose
assembly so that there is no strain on
the hose when the cooker is pulled
forward for cleaning or maintenance.
• The socket or the switch must be
accessible once the appliance is
installed.
HOT SURFACE
Connection point
Connection point
Hose assembly
Hose
assembly
Isolating tap
Isolating tap
Fig. 18