22 www.electrolux.com
• the system and electrical sockets
amperage is adequate for the
appliance maximum power (see
data label affixed on the back of the
cooker).
• the socket or system has an effective
earth connection in accordance with
current standards and prescriptions of
the law. All responsibility is disclaimed
if this is not complied with.
• The plug and socket or the multipolar
switch must be accessible after
installation of the appliance.
When connecting to the mains with a
socket:
• Fit to the power cable (if without) a
standardized plug, suitable for the
load which is indicated on the data
label. Connect the wires making sure
they correspond as shown below, and
remember that the earth wire must be
longer than the phase wires:
letter
L (phase) = brown wire
letter
N (neutral) = blue wire
symbol
(earth) = green/yellow wire
• The power cable must be laid so that
no parts of it ever reach a temperature
of 75 °C.
• For connecting do not use, adapters
or shunts as they could cause false
contacts resulting in hazardous
overheating.
When connecting directly to the
mains:
• Install a multipolar switch that can
withstand the appliance load, with
a minimum opening between the
contacts of 3 mm.
• Remember that the earth wire must
not be cut out by the switch.
Changing the flexible gas hose
In order to guarantee that the gas hose is
always in excellent condition we strongly
recommend changing it on the date you
will find printed on it.
Replacing the electrical
components
• The rear protection will have to be
removed in order to change the
electrical heating elements, spit motor,
terminal board and power cable.
• If you have to change the power
cable (see the cross section on table
“Technical Features” paragraph),
always keep the earth wire longer
than the phase wires and, in addition,
follow all the instructions given in the
“Electrical connection” paragraph.
• To replace the oven lamp please refer
to instructions on “Replacing the oven
lamp” paragraph.
• To change the lamp holder, the spark
generator and the spark electrodes,
the work top has to be removed as
indicated in paragraph “Replacing the
taps and thermostat”.
• To change the eventual programming
accessory, the commutator and the
indicator lights, remove the front panel
as indicated in paragraph “Taps” .