Electrolux EKG501102, Руководство пользователя, Страница: 17 / 24

electrolux
17
Gas feeding pipe fitting is Gc1/2.
For this type of installation, connection to
the gas supply should be carried out using
only and exclusively flexible metallic tubes in
conformity with rules in force.
Connection using flexible, non metal pipes
When the connection can be easily
inspected in its full extent, there is the
chance to use a flexible pipe according to
the rules in force.
The flexible pipe should be made ready for
use in such a way that:
- nowhere it can reach overtemperature,
other than room temperature, higher than
30°C; if the flexible pipe, to reach the cock,
must run behind the range, it must be
installed as shown.
- it is no longer than 1500 mm;
- it shows no throttles;
- it is not subject to traction or torsion;
- it doesn’t get in touch with cutting edges
or corners;
- it can be easily inspected in order to check
its condition.
clamp
connection of
flexible hose
power cord
clamp
connection of
flexible hose
power cord
IMPORTANT
Once installation is complete, check the
perfect seal of every pipe fitting, using a
soapy solution, never a flame.
Ensure that the rubber hose is not in contact
with any part of the back of the cookers as
is in the figure and that the loop of the hose
when connected is not in contact with the
floor when the appliance is in position.
NO
clamp
connection
of flexible
hose
power cord
Conversion of gas
Your cooker is designed to work with natural
gas, and is convertible for use with propane
or butane.
The LPG conversion kit is available from
your Service Force Centre and must be
fitted by an authorised Service Engineer.
For changing the gas type it is necessary to:
•
replace the nozzles (hob, oven and grill);
•
adjust the minimum level (hob and
oven);
•
check the gas connection;
Stick the label corresponding to the
type of gas used.