Electrolux EIDW6105GS0, Техническое и сервисное руководство

Страница: 98 / 104

T Trro ou ub blle es sh ho oo ottiin ng g
6-4
Water in the tub is
not staying at the
proper level.
At the end of the
cycle there is still
detergent in the
dispenser.
Dishwasher does
not perform all
functions in the
chosen cycle.
Dishwasher only fills
and drains. Can
not hear the wash
motor running.
At the end of the
cycle dishes are not
dry.
1a. Check and clean the drain valve.
1b.Check power to the drain valve from the
control to make sure the valve is closed.
1c. Check the motor of the drain valve for
resistance. Replace defective drain valve.
2a.The drain hose needs to loop all the way to
the underside of the counter top.
2b.The drain hose should not go under the
floor with out an air gap mounted in the
counter top.
1. See Problem: Dispenser is not opening.
2. Water can cause detergent to cake and not
dissolve properly. Close the cup cover
before adding fresh detergent to the cup.
3. See Problem: Dishwasher operates but
water not getting hot.
4. See Problem: Will not fill.
5. Make sure detergent is fresh and stored in
an air tight container in a dry location.
1. The cycle matrix is different for each cycle
and the control can change the cycle with
input from sensors.
1. See Problem: Wash motor not operating.
1. Plastic items do not dry well in dishwashers.
2. Ample outside air is needed for intake of
vent system.
3. Check incoming water temperature needs to
be at least 120°F.
4. Rinse aid is needed to speed evaporation of
water from the dishes. Fill rinse aid section
of the dispenser. Check setting of dispenser
and increase setting to aid in drying.
5. See Problem: Dispenser is not opening.
P Prro ob blle em m
C Co orrrre ec cttiio on n
1. The drain valve is not closed
properly.
2. Drain hose not installed
properly.
1. The cover for the dispenser
did not open.
2. The detergent was added
when the cup was wet.
3. The water was not hot
enough to dissolve detergent.
4. Dishwasher did not fill with
the proper amount of water.
5. Detergent not handled or
stored properly.
1. Check cycle criteria found in
the Service data sheet.
1. The wash motor may not be
operating.
1. Type of dishes that make up
the load.
2. Dishwasher installed in
closed cabinetry.
3. Incoming water not hot
enough.
4. The rinse aid dispenser is
empty.
5. Rinse aid is not being
dispensed in the cycle.
C Ca au us se e