Electrolux EIDW6105GS0, Техническое и сервисное руководство

Страница: 48 / 104

4-14
C Co om mp po on ne en ntt T Te ea arrd do ow wn n
F Fiig gu urre e 5 5--2 28 8.. L Le eg g a an nd d H Hiin ng ge e A As ss se em mb blly y R Re em mo ov va all
L Le eg g a an nd d H Hiin ng ge e A As ss se em mb blly y R Re em mo ov va all
The leg and hinge assembly extends from the top
frame brace down into the unit frame where a
screw secures the assembly to the unit frame.
Screws also pass from the interior of the unit
through the side wall and fasten into the leg and
hinge assembly.
To remove the leg and hinge assembly:
1. Remove unit from its installation position.
2. Remove the door assembly.
3. Remove upper and lower rack assemblies from
interior of unit.
4. Remove the roller assemblies and guide rails.
5. Remove the door strike from top frame brace.
6. Remove the corner trim and cabinet clip
bracket.
7. Remove the top frame brace.
8. Using a #20 Torx bit, extract the four screws
from each interior sidewall that secure the leg
and hinge assembly to the exterior of the unit
frame. (See Figure 5-28)
9. Tilt unit back to access the screw inside the
unit base. If blocking materials are not
available, the unit may be set on its back.
10. Using a #20 Torx bit, extract the screw from
the unit base securing the leg and hinge
assembly to the unit frame. The leg and hinge
assembly may now be pulled out from its
installation position. (See Figure 5-29)
F Fiig gu urre e 5 5--2 29 9.. L Le eg g a an nd d H Hiin ng ge e A As ss se em mb blly y R Re em mo ov va all
B Bo otttto om m S Sc crre ew w L Lo oc ca attiio on n
Leveling Leg
Front of Unit
Screw
Screw
Screws
Roller
Assembly
Components
Leg and
Hinge
Assembly