Electrolux EIDW6105GS0, Техническое и сервисное руководство

Страница: 55 / 104

4-21
C Co om mp po on ne en ntt T Te ea arrd do ow wn n
D Drra aiin n V Va allv ve e R Re em mo ov va all
The drain valve is intended to maintain the proper
level of water in the tub. This valve is installed
between the drain hose and the drain pump. The
valve consists of a check ball in a cradle, a motor
and a location cam and switch. The motor rotates
the check ball in the housing to open and close
the drain port. The cam and switch are used by
the electronic control to determine the location of
the ball at all times.
The valve can be checked at the control for
resistance with a desired reading of 1.09K ohms.
This is checked between the green and
green/yellow wires. The cam switch is read
between the remaining two green wires for the
valve. These will read open when the valve is
closed and read closed when the valve is open.
The drain pump can be checked for resistance at
the electronic control. The normal resistance for
the drain motor is 21.5 ohms.
To remove the drain valve:
1. Pull unit from its installation position. Lay unit
on its back.
2. Remove the base tray.
3. Using a flat bladed screwdriver, loosen the
tubing clamp from the input end of the drain
valve. Use a pliers to remove the spring clamp
from the tubing connected to the drain outlet.
Pull tubing from drain valve. (See Figure 5-42)
N NO OT TE E:: If unit was operated prior to service, water
may be present in the tubing. Have a towel or
absorbent material on hand when servicing water
system components.
4. Using a #20 Torx bit, extract the two screws
securing drain valve to the unit frame.
5. From the top of the drain valve, push back the
retaining clip with a small flat bladed screw-
driver and pull electrical connection from
drain valve.
F Fiig gu urre e 5 5--4 42 2.. D Drra aiin n V Va allv ve e R Re em mo ov va all
Screws
Electrical
Connection
Outlet
Tubing
Clamp
Inlet
Tubing
Clamp