Electrolux EIDW6105GS0, Техническое и сервисное руководство

Страница: 13 / 104

IIn ns stta alllla attiio on n IIn nffo orrm ma attiio on n
2-5
F Fiig gu urre e 2 2--3 3.. R Ro ou ug gh h--iin n D Diim me en ns siio on ns s
R Ro ou ug gh hiin ng g IIn n IIn ns stta alllla attiio on n
1. Make sure your location has the correct drain, water, and electrical outlets to make the connections.
Do not install unit under a cooktop range. Damage to tub or other components will occur.
2. Floor should be flat and free of any obstruction.
IIM MP PO OR RT TA AN NT T:: For proper operation and appearance cabinet opening should have dimensions as shown in
Figure 2-3. If unit is to be placed in a corner, there must be at least a 2-inch side clearance to open door.
IIM MP PO OR RT TA AN NT T:: Drain, water, and electrical lines should be roughed-in before going any further.
N NO OT TE E:: If dishwasher is installed at end of a cabinet, sides and back must be fully enclosed.
N NO OT TE E:: Cabinet Seal Kit (Kit # 154662101). This kit provides a seal between the unit and cabinets once
installation is complete. (The Installation Instructions are located in the Kit)
C Co on nn ne ec cttiio on ns s F Fo orr E Elle ec cttrriic ca all,, W Wa atte err,, a an nd d D Drra aiin n
1. Review dimensions in Figure 2-3 to locate dishwasher’s drain, water, and electrical connections.
All utilities must be routed in the shaded areas of Figure 2-3.
IIM MP PO OR RT TA AN NT T:: Disconnect power before starting installation.
2. Locate the electrical supply and the dishwasher’s electrical junction box on right underside of unit
behind kickplate assembly. (See Figure 2-2.)
3. Determine where you will connect to household hot water supply. Review Figure 2-2 and note the
location of water inlet valve. Determine where you will connect the drain hose.
4. Cut access holes for the electrical, water and drain hoses in the shaded areas as shown in Figure 2-3.
5. The dishwasher operates on a 120 volt, 60 Hz electrical supply. Provide a separate circuit with a fuse
or circuit breaker rated for at least 15 amps (20 amps if connected with disposer) but not more than
20 amps.