Electrolux EIDW6105GS0, Техническое и сервисное руководство

Страница: 40 / 104

4-6
C Co om mp po on ne en ntt T Te ea arrd do ow wn n
F Fiig gu urre e 5 5--1 12 2.. B Bo otttto om m D Do oo orr S Se ea all R Re em mo ov va all
Crimped Area
Bottom Door
S eal
F Fiig gu urre e 5 5--9 9.. H Hiin ng ge e S Sp prriin ng g C Ca ab blle e R Re em mo ov va all
D Do oo orr R Re em mo ov va all
The door assembly is secured with screws to the
hinge assembly. The hinge spring linkage must be
removed from the hinge assembly before removing
the door assembly.
To remove the door assembly:
1. Remove the outer door panel.
2. Disconnect wire leads from the user interface
and dispenser assembly. Remove wire har-
ness from wire clips on inner door panel.
3. With a pliers remove the cable of the door
spring from hinge assembly. (See Figure 5-9)
4. Open door assembly. Using a #20 Torx bit,
extract the 2 screws from each side of the
door that secures the door assembly to the
hinge assembly. (See Figure 5-10)
D Do oo orr S Se ea all R Re em mo ov va all
The door seal seals the area between the inner
door panel and the tub to prevent leaks. There are
two seals one mounted onto the bottom of the
inner door panel the other pressed into a channel
and mounted around the front of the tub.
To install the tub mounted seal, first determine the
inside and outside of the seal. The extended end
on the seal goes toward the inside of the tub.
(See Figure 5-11) Start by finding the center of the
gasket and press this into the channel at the door
strike. Next take the gasket to the top corners and
press into the channel. Continue to the bottom on
either side, then work up from the bottom,
pressing the seal into the channel, working to the
center. Close door and press in place.
B Bo otttto om m D Do oo orr S Se ea all
The bottom door seal is located at the bottom of
the inner door assembly. The door seal slides
under a lip formed in the door assembly and is
secured in pace by crimping the outer edge of lip.
To remove the bottom door seal:
1. Remove the outer door panel.
2. Remove toe and kickplate.
3. Remove door from unit.
4. Using a small flat bladed screwdriver or putty
knife, pry out the crimped area until the bottom
door seal can be removed from door assembly.
(See Figure 5-12)
5. When installing, crimp door lip until seal
cannot be pulled from the door.
Out s ide
of S eal
In s ide
of S eal
End Mounted In Channel
F Fiig gu urre e 5 5--1 11 1.. D Do oo orr S Se ea all R Re em mo ov va all
F Fiig gu urre e 5 5--1 10 0.. D Do oo orr R Re em mo ov va all
Grab Here
With Pliers
Door Hinge
Screws
Spring
Cable