50
Remove the support from the telescopic flue
by unscrewing the two screws that fix it to the
flue (one per side - save the screws - Fig. 10).
Remove deflector F from the support by
unscrewing the 4 screws that fix it to the
support (save the screws - Fig.10).
Fix the telescopic flue support to the ceiling.
The support has a reference mark that must
correspond to the line previously traced on the
wall (Fig. 10).
Mark where the holes for fixing the support
should be made with a pencil, and drill (Ø 8
mm).
Insert two dowels and fix the telescopic
support with two 5x45 screws (Fig. 10).
Fix the end of the waste disposal tube onto
connection ring B and the other end to the
conduit for evacuating fumes (aspiration
version) or the connection ring of ventilator
screen F (recirculation version).
Attention! Concerns only the EFCR 942
model:
Connect the waste disposal tube to one
external aspiration unit (see following
paragraph Connection to an external motor).
Connect the electricity.
Attention! Only for the EFCR 942 model:
It is also necessary to carry out the electrical
connection to an external aspiration unit (see
following paragraph Connection to an external
motor).
Check, in the case of a non-return valve being
used, that it is functioning correctly and is not
blocked by the tube.
Fix the upper part of the hood to its support
with two screws (Fig. 10).
Slide the lower section of the flue downwards
and insert it into the apposite housing on the
upper part of the hood.
Mounting the grease filter
Position the filter at the back of the hood and
move the handle upwards until the filter is
blocked.
3,5 x 13
1
a
b
b
3,5 x 13
2
c
2,9 x 6,5
3
d
Fig. 10
B
F
