47
MODEL
PNC
Serial No.
Lamp
Motor
When the hood does not function
If your appliance fails to work properly please carry out the following checks.
Symptom
Solution
The cooker hood will not start...
Check that: The hood is connected to the electricity supply.
Check that a fan speed has been selected
The cooker hood is not working
Check that: The fan speed is set high enough for the task.
The grease filters are clean.
The kitchen is adequately vented to allow the entry of fresh air.
If set up for recirculation, check that the charcoal filter is still effective.
If set up for extraction, check that the ducting and outlets are not blocked.
The cooker hood has
switched off during operation...
The safety cut-out device has been tripped.
Turn off the hob and then wait for the device to reset.
If the hood has been installed below the heights indicated in the
installation instructions the motor will cut-out frequently which will
damage the hood.
If after all these checks, the problem persists, contact your local
Service Force Centre, quoting the model and serial number.
Please note that it will be necessary to provide proof of purchase
for any in-guarantee service calls.
In-guarantee customers should ensure that the above checks have
been made as the engineer will make a charge if the fault is not a
mechanical or electrical breakdown.
Accessories
:
Type 160 active carbon filter
External motor (for external installation) 942 121 135
External motor (for external installation) 942 121 182
Changing the lamp
The hood must be disconnected from the power
supply when changing the lamp. Carry out the
change in this way (
Fig. 5):
·
Remove the protective glass of the lamp with a
screwdriver.
·
Substitute the lamp with an equivalent one.
·
Remount the protective glass of the lamp.
Fig. 5
