VIRONMENTAL TIPS
ARNING
CAUTION
Automatic aerosol systems (such as insect control)
should not be located adjacent to the product as the
spray may cause long term damage to the external
plastics of the appliance.
Do not put the refrigerator in a location that is too
cold or is unprotected, for example in a garage or on a
veranda. The ambient temperature should be above 10°C.
Put the refrigerator in a dry place avoiding areas of high
moisture or humidity.
Ensure the refrigerator is located on an even surface.
Adequate ventilation around your refrigerator
The diagram below shows the recommended airspace to
allow for ventilation of your refrigerator.
350mm
50mm
Recommende
d
air
spac
e
CABINE
T
DOOR
30mm
30mm
X
Y
If you have a cupboard above the refrigerator with a rear
gap of less than 100 mm (Y), recommended clearance at
the top of the refrigerator increases from 50mm to 90mm
(X) minimum.
When positioned in a corner area, spacing of at least
350mm (300mm for multi-door models) on the hinge side
will allow the doors to open enough to enable the removal
of bins and shelves.
NOTE: Doors are designed to sit proud of cabinetry
(not flush). The clearances shown above are the
recommended minimum clearances.
The clearance at the rear must not exceed 75mm.
Unpacking
ENVIRONMENT
Most of the packing materials are recyclable. Please
dispose of those materials through your local recycling
depot or by placing them in appropriate collection
containers.
Important – check for any damages or marks. If you find the
refrigerator is damaged or marked, you must report it
within 7 days should you wish to claim for damage/ marks
under the manufacturers warranty. This does not affect
your statutory rights.
Clean your refrigerator thoroughly following the instructions
in the “Cleaning” section and wipe off any dust that has
accumulated during shipping.
Locating the refrigerator
Installing your refrigerator
1.
Roll the refrigerator into place.
The rollers are
designed for forward or backward movement only.
They are not castors. Moving the refrigerator
sideways may damage your floor and the rollers.
Before moving your refrigerator ensure height
adjusting nut and the stability foot are fully wound up
off the floor.
2.
Wind the large height adjusting nut under door hinge
down until the refrigerator is tilted back by 10mm
(see diagram).
Height adjusting nut
Fixed rear rollers
10 -15mm
3. Wind the large height adjusting nut on the handle side
down until the refrigerator is level and stable. If you
have difficulty winding the nut or height adjusting foot
down, have someone tilt the refrigerator back so you
have better access.
stability foot
wound up
4. Check the alignment of the refrigerator to the
surrounding cupboards to see if it is level. You can
adjust the level as detailed in step 2 and 3.
aligned to
cupboards
ie. even gap
top of refrigerator is
level ie. horizontal
adjust front feet for
uneveness of floor
eg. wind this foot
down or up
8
INSTALLATION
INSTALLING YOUR NEW
REFRIGERATOR
