Electrolux E32AR75FPS, Техническое и сервисное руководство

Страница: 79 / 112

Component Teardown
6-15
Drain Pan Removal
The drain pan is secured with four screws to bottom of
the unit frame.
To remove the drain pan:
1. Pull unit from its installation position to access the
rear compressor area. Disconnect power from unit.
2. Extract the screws securing the compressor shield to
the unit frame and remove from unit.
3. The rear of the unit may need to be raised to access
the drain pan screws.
4. Using a short phillips head screwdriver, extract the
two screws securing the drain pan to the bottom of
the unit frame. (See Figure 6-31)
5. Position unit to access the front of the unit. Remove
kickplate.
6. The front of the unit may need to be raised to access
the drain pan screws.
7. Using a short phillips head screwdriver, extract the
two screws securing the drain pan to the bottom of
the unit frame. (See Figure 6-31)
8. Allow the drain pan to drop down. Pull drain tube
from drain pan.
9. Pull condenser tubes out of the retainers mounted to
the drain pan. Drain pan may now be removed from
the unit.
Condenser Fan Motor Removal
The condenser fan motor is secured with three screws
to the condenser fan motor bracket. Two hooks and two
screws at the base of the condenser fan motor bracket
secure the assembly to the unit base. (See Figure 6-32)
To remove the condenser fan motor:
1. Pull unit from its installation position to access the
rear compressor area. Disconnect power from unit.
2. Extract the screws securing the compressor shield to
the unit frame and remove from unit.
3. Disconnect wire harness from the wire leads of
condenser fan at quick disconnect.
4. Remove the four drain pan screws. Allow the drain
pan to drop from its installation position.
5. With a needle nose pliers, reach behind air dividers
and compress the plastic retainers while pushing
them out of the condenser fan mounting bracket.
Remove air dividers.
6. Using a 1/4” socket or wrench, extract the two
bolts securing fan mounting bracket to unit frame.
7. Using a phillips head screwdriver, extract the three
screws securing the fan motor to the fan mounting
bracket.
8. Pull fan motor and fan blade out from behind the
mounting bracket. Remove fan blade by pulling the
fan blade from the motor shaft.
Figure 6-31. Condenser Drain Pan Removal
Screws
Screws
Bolts
Grommet
Retainer
Figure 6-32. Condenser Fan Motor Removal
Screws
Plastic
Retainers
Air Divider
Use caution when tilting a freezer unit. Use
sturdy blocking materials that will not allow the
freezer to rock or tip over when servicing unit.