Electrolux E32AR75FPS, Техническое и сервисное руководство

Страница: 22 / 112

Installation Information
2-10
Installing Trim & Grill Assembly
Into Cabinetry
1. First, place protective covering where side trim will
contact the floor near rough opening. Then, stand
up the grill and frame assembly and center in rough
opening. You may need to use several pieces of
tape at the top corners and top center to temporarily
hold the assembly in place. (See Figure 2-15).
2. Making sure the frame is flush up against the front
surface of cabinetry, carefully run one mounting
screw (M) through the center hole of the top trim (A)
and into the cabinetry. DO NOT tighten at this time.
3. Level the top of the trim frame using a carpenter’s
level. (See Figure 2-16).
Some cabinet substrates may require pre-drilling holes
using a 1/8” diameter drill bit.
Figure 2-15.
Figure 2-16.
4. Shim as necessary (shims are not included). (See
Figures 2-17 and 2-18). Next, secure both ends
of top trim (A) to cabinetry using two 3/4” mounting
screws (M) through the holes at each end. Make
sure all screws are snug across the top.
5. Using a carpenter’s level, check that each side is
vertical. Shim as necessary (shims are not included).
Next, secure top and bottom of each side trim to
cabinetry using two 3/4” mounting screws (M). (See
Figure 2-19).
Figure 2-17.
Figure 2-18.
Figure 2-19.