Technical Support - A.D.L.
10/83
599 74 12-51 Rev.00
3.2.5
Pushbuttons – LEDs and LCD
The functions of each button are defined by the configuration of the appliance.
•
Button no. 1
: ON / OFF
This button is always present, whatever the styling.
−
Press it to turn the appliance on.
−
To turn the appliance off, press the button and hold it down for
approximately 1 second, after which time the buzzer plays a
melody (where enabled), the LCD display and LEDs are turned off,
all the options selected and any programme in operation are
cancelled.
The operation of the ON / OFF depends on the configuration of the
main circuit board. It can cut the appliance off from the electricity
mains completely (0 Watt circuit) or set the appliance to low energy
consumption mode (without 0 Watt circuit) in which case you will
need to take the plug out of the socket to cut off the electricity
supply completely.
•
Button no. 2
: TEMPERATURE
It is related to 5 LEDs (L1).
The starting temperature shown on the LCD display is the one set
for the programme selected.
Press this button in sequence to lower the temperature, when the
lowest temperature is reached the selection will start again from the
highest one available for the programme.
The temperatures available (displayed in °C) are:
95°C, 60°C, 50°C, 40°C, 30°C, 20°C, cold cycle.
•
Button no. 3
: SPIN SPEED
It is related to 5 LEDs (L2).
The initial speed displayed is that set for the chosen programme.
Pressing the button in sequence will reduce the speed and once
the lowest selection has been reached, the next one is “Rinse hold”
and the relative symbol
lights up (if compatible with the the
selected programme).
Pressing this button again will take you back to the highest speed
available for the selected programme.
The spin speeds are:
1,600–1,400–1,200–1,000–800–600–400–
.
