Technical Support - A.D.L.
29/83
599 74 12-51 Rev.00
8.3 Rapid reading of alarms
The last three alarms can even be displayed if the selector is not in the tenth diagnostic position or the machine
is in normal operation (e.g. while a washing programme is in progress):
•
Press
the
START / PAUSE
button and the nearest
option button
simultaneously (as if you were entering
DIAGNOSTIC mode) for at least 2 seconds: the LCD display shows the last alarm.
•
The alarm is displayed until another key is pressed.
•
While the alarm is being displayed, the appliance continues to perform the cycle or, if in the programme
selection phase, it maintains the previously selected options stored in the memory.
8.4 Deleting the last alarm
It is good practice to cancel the alarms stored:
•
After reading the alarm codes, to check whether the alarm re-occurs during the diagnostic cycle.
•
After repairing the appliance, to check whether it re-occurs during testing.
Series 6
Series 7
1. Enter the diagnostic mode.
2. Turn the programme selector clockwise to position ten.
3. Press
the
START / PAUSE
button and the nearest
option
button
simultaneously (as shown in the figure).
4. Hold down the buttons (for at least 5 seconds) until the LCD display shows “E00”.
N.B. With this operation all the alarms stored are deleted.
