Electrolux Professional Clarus Vibe WH6-11, Руководство пользователя

Страница: 17 / 36

User manual
17
Header module: General
The parameters that are valid for the whole wash program are set in the header module.
• Start pumps at
– Set the temperature at which dosing pumps should start in case “start at temperature” is selected in the wash module.
• Heavy soil option
– If set to “ON”, a heavy soil button will be shown on the start screen. If the user selects this option the washing time will
increase.
• Extra rinse option
– If set to “ON”, a extra rinse button will be shown on the start screen. If the user selects this option one rinse will be
added. The added rinse is a copy of the second last rinse or, in case the program has only one rinse, a copy of the last
rinse but without chemical dosing.
• Residual moisture and Dryload reduction
– These parameters should be set in wash programs for loads that are wet when loaded, for example floor cleaning
mops. Enter the known residual moisture* that will be weighed in the weighing module in the wash program.
Select Dryload reduction to get the correct amount of water and chemicals related to the calculated weight of the dry load
instead of the measured load.
Tip: Wash programs for floor cleaning mops should start with pre rinse(s) followed by an extraction before the
weighing module.
* How to calculate the residual moisture value: Run the program with dry, clean mops with known weight and
abort the program after the extraction. Measure the weight of the damp mops and calculate the residual moisture
RMC=((weight of the damp – weight of the dry) / weight of the dry) x 100.
• Use calculated weight*
– Select if the dosing of chemicals and the water levels should be related to the calculated weight of dry load instead of
the measured load. (Mainly used for cleaning mops).
• Water reduction
– Select if water levels should be adjusted to the weight of the load.
• Maximum and minimum laundry weight (only on machines with built in scale)
– Enter the maximum and minimum laundry weight in % of the machines capacity. It will not be possible to start the wash
program if the load is outside these boundaries when overload/underload protection is activated in the settings menu.
• Safe disinfection
– Set this parameter in thermal disinfection programs if you want “ Safe disinfection” receipts in the downloaded reports.
Note that you need to select “Maintain temperature” in a wash module as well.
• Buzzer at program end
– If set to “ON”, there will be a sound when the wash program has ended.
Weighing
A weighing module is necessary to get water, energy and chemical savings. The weighing module can be placed either at
the beginning of the program or after a pre-rinse followed by extraction.
The weighing module has no parameters.
The weighing of the load is either done by a weighing sequence where the drum is spinning or by the option “Integrated sav-
ings” (a built-in scale).
Dosing of chemicals
There are 16 chemical types in the list. In case none of them suits the process you can select another chemical type. Tap on
the chemical type and you will see a drop-down list with additional chemical types.
Branded chemical names will be shown if they have been added to the chemical type in the “Pump menu”.
Note!
It is not possible to use the same chemical several times in a wash module. In case you want to use the same chem-
ical more than once in a wash module you have to created two wash modules without a drain in between.