Electro-Voice® Tour X Owner’s Manual
4
Suspending TX1122, TX1152, and TX2152 (cont’)
Prior to use, inspect the suspension point(s) and associated hardware for any cracks, deformations,
broken welds, corrosion, missing or damaged components which could reduce the suspension point(s)
strength. Replace any damaged hardware. Never exceed the limitations or maximum recommended load
intended for the suspension point(s). As an added safety measure, it is suggested that the user install an
extra suspension point back to the building structural supports. This redundant safety point should have
as little slack as possible (less than one inch is preferable). Prior to each use, inspect the loudspeaker
enclosures for any cracks, deformations, missing or damaged components, which could reduce enclosure
strength. Replace any loudspeaker systems that are damaged or missing hardware.
To install the eyebolts, remove the 3/8” screw in the desired locations and replace with the fender washer
and eyebolt (Figure 2). If the eyebolts are removed, reinstall the screw; otherwise air leaks will occur in
the enclosure, resulting in undesirable performance.
Figure 2a:
Removing the 3/8” Screws from
the Loudspeaker
Figure 2b:
Installing the Fender Washers and
Eyebolts to the Loudspeaker
