ELECTRO FREEZE SLX400E, Руководство оператора

Страница: 38 / 74

28 184584
ELECTRO FREEZE Soft Serve Models SLX400E, SLX500
10 Start-up Instructions
The washing and sanitizing instructions
explained in this section are procedures
to remove bacteria and maintain a clean,
sanitary freezer. The freezer must be
disassembled and washed according
to the instructions in this manual before
sanitizing to ensure the best possible
cleanliness. Follow these directions for
each cylinder to be used.
CAUTION
To prevent bacteria growth,
use only approved sanitizers
to sanitize the machine.
Sanitizing must be done just
prior to starting the machine.
Failure to do so could create a
health hazard.
10.1 Sanitizing
NOTE: It is your responsibility to be
aware of and conform to the requirements
for meeting federal, state and local laws
concerning the frequency of cleaning and
sanitizing the freezer.
Important:
This sanitizing step is always done just
prior to starting the freezer.
1. Wash and sanitize your hands and
forearms.
2. Prepare 2 gallons (7.6 liters) of
sanitizing solution for each hopper.
The sanitizing solution must be
mixed according to manufacturer’s
instructions to yield 100 PPM (parts
per million) available chlorine
solution (example: Stera-Sheen
Green Label). Use warm water (100-
110°F or 38-43°C) to wash, rinse,
and sanitize. Make sure sanitizer is
mixed thoroughly and has completely
dissolved.
Important:
Do not use unapproved sanitizers
or laundry bleach. These materials
may contain high concentrations of
Figure 10-2 Sanitize
hopper and its
components
— continued
chlorine and will chemically attack
freezer components.
3. Place the mix feed tubes and
regulators in the bottom of the hopper
pans. Do NOT place regulator into the
mix feed tube. See figure 10-1.
Important:
Never let the sanitizer remain in the
freezer for more than 15 minutes.
Important:
Do not insert any tools or objects into
the mix feed port or head dispensing
hole while the freezer is running.
4. Pour 2 gallons of sanitizing solution
into each hopper
pan. Using a clean
brush, scrub the
hopper walls, mix
level sensors and
the mix feed ports
from the hoppers
to the cylinders,
as shown in figure
10-2.
5. Sanitize the inside
of the hopper
covers.
Figure 10-1 Mix Feed Tube Assembly
INSERT - MIX FEED TUBE SLEEVE - REAR MIX FEED
TUBE - REAR MIX FEED
O-RING