Electro-Air EASASD-10ASC, Руководство пользователя

Страница: 6 / 16

Note: There may be some arcing or snapping sounds
from the collecting cells. This is normal when the unit is
new. In about 2 weeks, as the sharp edges of the cells
become smoother, the arcing will disappear.
OPERATION
The Air Cleaner will run as long as there is adequate
airflow through the ducts. The Air Cleaner will not run if
the system fan is off. For proper operation, follow these
simple steps:
1. Run heating/cooling system fan continuously, and on
low speed if available.
2. Remove furniture or carpets which block return air
grilles throughout your house, so that air moves
freely to the furnace/ air conditioner.
3. Check for proper operation of the system fan.
WHITE DUST
After installation of the Air Cleaner, you may notice
some white dust on tabletops and shelves. Most large
particles such as lint, are too heavy to remain airborne
and tend to settle quickly, never reaching the air cleaner.
This white visible dust is normally referred to as
“ clean dust.” As the Air Cleaner is removing the dark and
staining particles from the air, the lint will also be cleaner.
Lint dust is most noticeable on dark furnishings; in
homes containing new carpeting; and where there is a lot
of household traffic from occupants and pets. To reduce
lint dust, use continuous fan operation and keep return
vents unrestricted to create an efficient airflow.
Note: The Air Cleaner does NOT produce more lint or
dust.
MAINTENANCE
It is important to follow a scheduled maintenance for
maximum performance of the Air Cleaner.
Cell And Prefilter Cleaning
The collecting cells and prefilters must be cleaned on
a regular basis for the Air Cleaner to function at its peak
of efficiency. The frequency of cleaning will vary from
one house to another. On average, the cells should be
cleaned every 3 months.
1. Remove access door, collecting cells and prefilters.
2. Place cells in a laundry tub. Rinse with hot water and
spray completely with DAX Detergent (or a non-
chlorine, non-corrosive, non-abrasive liquid
household detergent. Allow detergent to run down
both sides of plates and ionizing wires. Let stand for
5 minutes or fill up laundry tub with water and DAX
Detergent, and dunk cells up and down until water is
dirty.
3. Rinse cells well with hot water (maximum 120°F/
49° C).
4. To remove contaminate from the ionizing wires, use
an old toothbrush. Slide the brush bristles over the
wire and gently drag the brush up and down the wire
once. Be very careful when cleaning the wires as
they become very brittle with age.
5. If dirt remains, let cells soak in a solution of DAX
Detergent and water for 30 minutes.
6. Tilt cells on 45° angle on their short side, with arrows
pointing sideways. Allow to dry completely,
approximately 12-24 hours. A hair dryer may be used
to speed up drying time.
7. To wash prefilters, spray with DAX Detergent, rinse
and let dry. Do not wash in the same water as
collecting cells.
8. Do not place the cells in the air cleaner if they are
wet.
9. Place cells and prefilters back into cabinet. Close
door and turn power switch ON. If the performance
light does not come on or arcing occurs, turn Air
Cleaner OFF and allow air from system fan to dry
cells completely.
Activated Carbon Filter Replacement
Carbon filters help remove odors from the air. Carbon
filters should be replaced every 3 - 6 months. Filters are
NOT washable. Replacements are available through your
installer or dealer. To replace filters, perform the following
CAUTION
Make sure to turn Air Cleaner and system fan OFF
before performing any maintenance or removing any
components.
CAUTION
Damage to cells may occur if improperly handled or
washed. Do not wash cells in a dishwasher. Never use
any object to clean between the cell plates, as this may
cause damage to plates or ionizing wires. Never place
cell in oven to dry. The edges of the cell may be sharp -
handle with care.
6
Replacement Carbon Filters:
EASASD-10, EASASD-11
Set of 3 Part #1156-3
EASASD-12, EASASD-18 Set of 3 Part #1856-3
Fig. 6 — DAX Detergent and Carbon Filters are
available from your installer or dealer.
DAX 32 oz Spray Bottle Part #9900