Motion detector Ms18
Motion detector Ms18
1.
Control Indicator
- Lights
up when a signal is
transmitted.
2.
PIR
3
.Tamper contact.
4.
Battery compartment
(2xAA, 1.5V).
5.
Sensitivity switch ½
Iin setting 1 the sensor will
iinstantly react to movement,
in setting 2 the sensor is less
sensitive and will only react
after registering multiple
movements.
6.
TEST button.
Mounting the Motion Detector MS18
The motion detctor works by detecting changes in temperature. Do not mount the detector too close to a heater or
air conditioner.
The motion detector has a range of 12m and an angle of 90. Because of the special lens the sensor ‘looks down’.
Always mount the Ms18 at a height of about 180cm from the floor and place it in such a way that the detector can
cover the area you want to secure. The mounting bracket can be placed at an angle (90) or directly against the
wall.
Using the Motion Detector
1. Open the battery compartment and insert the batteries (2xAA, alkaline)
2. Keep the TEST button (6) pressed for about 4 seconds. The LED will flash once. Release the button. The LED
will flash twice. The motion detector has now chosen a unique code, which can be registered with your console.
Place the motion detector upside down so that it can’t detect any movement during registration.
Place the sensor as high as possible: This gives the best range. Do not place the sensor directly on a metal
surface or in direct sunshine.
Test mode: Testing the location of your motion detector
1.Set the switch (5) to 1 and press the TEST button (6) until the indicator (1) flashes twice.
2. Wait 20-30 seconds.
3.Walk in front of the sensor. The indicator (1) lets you know when a movement has been detected. This allows
you too check whether the sensor has been mounted on the right place.
4.Press the TEST button again to be able to use the sensor as normal.
After 2 minutes the motion detector will go back to the normal mode.
Registering a motion Detector with the Console
1. To access the menu press the menu
upp
or nenu
down
button. The display now shows ENTER PIN.
2. Enter your 4-digital PIN code (factory setting 0000 for changing PIN code see page 12)
.
3. When the PIN code has been entererd correctly, the word INSTALL will show up on the display.
4. Press OK. The display will read INSTALL ZONE.
5. Press the TEST button of the motion detector or turn it around, so that that the sensor will detect movement.
The console will beep to confirm. The display will read Zone 1 SET.
A memory space for a sensor is called a zone. If you have more than 1 sensor installed, it will show e.g ZONE 2
SET, ZONE 3 ZET, ZONE 4 SET, -- ZONE 30 SET.
You can choose in which zone you want to install the sensor. If you want to install the sensor in zone 3, press 3 on
the number pad before executing step 5. It’s advisable to write down which sensor you have registered in which
zone.
6. Repeat step 5 for every motion detector you wish to register.
7. Press CLEAR again to quit the menu. To confirm your choice, press 1 for Yes or 2 for No. If uou choose Yes,
you will quit the menu. If you choose No, you go back to the first menu item.
NOTE You can also use motionsensor Ms10 to the alarm.
7
MS18E
