CTC-1132 868AM 2007.07.18
2
II. Insert GSM SIM Card
CTC-1132 Control Panel features built-in GSM
communication facility to make message
reporting to the phone numbers pre-
programmed within the system.
z
To Insert your SIM card:
The GSM component is situated inside the
Power Supply compartment as pointed out
by the arrow below:
SIM CARD
z
Unlock the SIM card base by sliding the
cover toward “
OPEN-backward
” direction.
z
Spring open the SIM card slot and insert
your new SIM card.
z
Replace the SIM slot onto the base lightly.
z
Remember to lock the SIM card base by
sliding the cover toward “
LOCK-forward
”
direction.
<
<
I
I
M
M
P
P
O
O
R
R
T
T
A
A
N
N
T
T
N
N
O
O
T
T
E
E
>
>
Be aware to only insert or remove SIM card
when the Control Panel is completely
depleted of any power residual.
III. The Power Supply
An AC power adapter is required to connect to
a wall outlet. Be sure only to use an adapter
with the appropriate AC voltage rating to
prevent component damage. A DC 9V output
and 500mA adapter is generally used to power
the Control Panel.
z
Rechargeable Battery
z
In addition to the adapter, there is a
rechargeable battery inside the Control
Panel, which serves as a back up in case
of a power failure.
z
The battery used is a Ni-MH 600mAH
7.2V rechargeable battery.
z
During normal operation, the AC power
adapter is used to supply power to the
Control Panel and at the same time
recharge the battery.
z
When the battery is fully charged, it can
provide back-up power for a period of
about 8 hours. It takes approximately 48
hours to fully charge the battery.
<
<
N
N
O
O
T
T
E
E
>
>
"
If the AC power is missing and the
battery is near exhaustion, a low
battery message will be displayed and
the internal siren and Backlit feature
will be disabled to conserve power.
IV. How to install the Control
Panel
The easiest way to get to know the system
and get it up and running quickly is to get
all the devices and accessories
programmed on a tabletop before locating
and mounting them.
The Control Panel can be mounted on the wall
or wherever desired. Ensure the Control Panel
is fitted at approximately chest height where
the display can be easily seen and the keypad
convenient to operate.
z
Using the 2 holes of the Wall Mounting
Cross Bracket as a template, mark off the
holes’ positions.
z
Drill 2 holes and fix the screws & plugs
provided.
z
Hook the CTC-1132 unit onto the Wall
Mounting Cross Bracket (holding the unit
with the front facing you).
