Electia CTC 1132, Руководство пользователя

Страница: 28 / 128

CTC-1132 868AM 2007.07.18 26
Operation
I. Entering User Menu
When the system is in Disarmed mode (Alarm
off), entering a valid user code can access the
user menu, the system can then be Away
armed or Bypass armed via this menu.
When the first numberic key is pressed, the
display will show:
E n t e r C o d e
¿ . . .
when the complete PIN code is keyed in
followed by
“ OK ”, within 10 sec., the first two
li
nes of the user menu is shown:
A w a y A r m
H o m e A r m
A flashing dot will appear next to “ Away Arm ”,
the complete menu list consists of:
A w a y A r m
H o m e A r m
B
y p a s s
L o g
Wa v e m a n
These items can be scrolled through by using
the “
T
”, “
S
” keys.
< < N N O O T T E E > >
)
If there is any fault event occurred, no
matter if the fault condition has been
rectified or not, when you enter the
PIN Code followed by “
OK ”, the
following screen will be displayed.
F a u l t D s p
A w a y A r m
H o m e A r m
B
y p a s s
L o g
P
o w e r S w i t c h
And the cursor stays at “ Fault Dsp ”
position. To arm the system, please
see the section “
Forced Arming ”
below.
)
If there is any SMS message saved, the
screen will display SMS for SMS
message reading
)
If you press “ ” while the “ Alarm off ”
is displayed, a “ Enter Code ” promp
screen will be displayed. After you
enter your pin Code, the above screen
will also be displayed.
)
After 30 seconds of key-inactivity, the
system will automatically exit User
Menu and return to
“ Alarm off ” mode.
II. Away (Alarm ON) Mode
1. Arming the system
If the system is in Disarmed mode (Alarm off),
to arm the system.
Step 1. Enter your PIN code and press “ OK ”.
The display will show :
A w a y A r m
H o m e A r m
B y p a s s
L o g
Wa v e m a n
and the cursor stays at “ Away Arm ”
Step 2. Press “ OK ” and the screen will display.
T i m e T o E x i t
3 0 s e c
The defined EXIT Delay is displayed on the
second line, and is counting down. During the
EXIT Delay period, the exit sound plays, unless
it has been chosen to switch off.
Step 3. When the Exit Delay time is up, or the
“ Entry ” Door Contact (Final Door Set
Function programmed to be “ On ”) is
closed, the Control Panel will sound a
long beep. The “
Alarm On ” will
display on the screen and the system
is in Arm mode.
A l a r m O N
0 7 : 2 5 1 6 D e c
<
<
N
N
O
O
T
T
E
E
>
>
)
When “ Final Door Set Option ” is set to
“ Off ”, the Control Panel enters “ Alarm
On ” mode only when the Exit Delay
time is up.
)
The Control Panel has “ Screen Save ”
function. The “ Alarm on ” message
will be displayed for 160 sec. only.
Afterwards only current date & time is
displayed on the second line.