P
OSITIONING
Your Elecro heater must be screw fixed to a firm base or wall. The heater
MUST
be
horizontal and upright i.e. with the control enclosure located above the Titanium
flow tube (see diagram below). Under no circumstances should the heater be oper-
ated in any other orientation.
The heater should be installed at a low point in the filtration system. It should be po-
sitioned after (i.e. downstream) of the filter but before (i.e. upstream) of any dosing
or other water treatment plant.
NOTE If the
flow direction
is reversed
(explained
later in this
booklet) the
heater
MUST
remain sited
after the filter.
Only clean filtered water
should enter the heater.
N
OTES
[Blank Page For Your Notes]
