Ele 46-4825, Руководство по эксплуатации

Страница: 4 / 7

Heater/Magnetic Stirrer Unit
46-4825
Original Instructions 4 9907X0067 Issue 2
Danger : Installation and servicing must be carried out by a qualified person.
Danger : A good low impedance Protective Earth Ground connection is recommended
for this product.
Danger : Check that the power supply is compatible with the requirements stated on
the voltage label on the unit and connect in accordance with IEE regulations or to local
requirements.
Power Cable is coded as follows:-
Brown wire L Live or Power
Blue wire N Neutral
Green/Yellow wire E Earth or Ground
6 Operation
6.1 Caution : Always use suitable protective garments and gloves to protect the operator
from burns and scalds during use of this product.
6.2 Control panel and power switch.
Main Power Switch Heater Element On Stirrer Motor On
Temperature Regulator Stirrer Speed Regulator
6.3 Place the required liquid in the beaker and place the beaker onto the heater platform.
Note : To get the correct temperature control during the test it might be necessary to
use a heat transfer material between the beaker and heater platform.
6.4 Turn all the controls to their minimum positions and then switch on the mains switch on
the front panel. Place the small stirrer bar into the liquid in the beaker and then, using
the stirrer control knob, adjust to a suitable speed for stirring the liquid.
6.5 To start the heating process, adjust the temperature using the temperature control
knob to add the required amount of heat to the liquid in the beaker.
6.6 CAUTION : Make sure that the liquid being heated does not get too hot